Feeding In Compile Tray - Dell 5130cn Service Manual

2.5 Feeding in Compile Tray

While the GUIDE PAPER 240 (PL 14.5.38) slides out toward the Stacker Tray, driven by the MOTOR
ASSY EJECT (PL 14.5.6), the ROLLER ASSY EJECT PINCH (PL 14.6.3) retracts upward to allow the
sheet to come in from the X' port.
The sheet coming in from the X' port falls onto the Compile Tray.
When stapling or tamping is not specified, the ROLLER ASSY EJECT PINCH lowers to allow the sheet
to exit to the Stacker Tray. (Refer to 2.6 Ejection to Stacker Tray.)
When stapling or tamping is specified, the ARM ASSY PADDLE (PL 14.6.4) lowered by the SOLENOID
ASSY (PL 14.6.20), upon the falling of the sheet onto the Compile Tray.
Then, the PADDLE SUB (PL 14.6.8) of the ARM ASSY PADDLE and the Main Paddle of the SHAFT
ASSY MAIN PADDLE (PL 14.7.13) rotate driven by the DRIVE ASSY TRANS (PL 14.7.6), to slide the
sheet backward (reverse to the exit direction) until it stops against the flange of the Compile Tray.
GUIDE PAPER 240
Stacker Tray
Stacker Tray
Finisher Service Manual
Version 1 2009.03.31
ROLLER ASSY EJECT PINCH
Paper
Compile Tray
PADDLE SUB
Paper
Compile Tray
6 – 6
Chapter 6 Principles of Operation
ROLL ASSY DRIVE EXIT (X-port)
ARM ASSY PADDLE
SHAFT ASSY MAIN PADDLE
Tbt06105KA