Figure 2.4 P-P Connection (Isdn: E-Mail) (Using The Remcs Port) - Fujitsu Primequest 2000 Series Installation Manual

CHAPTER 2 Before Using the REMCS Service
2.2 Connection Configuration for Connecting to the REMCS Center
FIGURE 2.3 P-P connection (ISDN: e-mail) (using the network connected to a USER port)
Through a network that is not connected to a USER port

FIGURE 2.4 P-P connection (ISDN: e-mail) (using the REMCS port)

REMCS port to connect to a network other than the network connected to a USER port.
There are two types of configuration: one has the REMCS port connected directly to the ISDN router, and
the other has the HUB (router) connected to configure a dedicated LAN with other units and to connect the
ISDN router to the HUB
Remarks
- The IP address for [MaintenancePort] must be set from the MMB Web-UI. However, DNS cannot be
specified.
- Be sure to use the IP address to specify the SMTP server.
FIGURE 2.4 P-P connection (ISDN: e-mail) (using the REMCS port)
shows a configuration that uses the
5
CA92344-0542-02