Setting The Periodic Connection Schedule; Figure 3.6 [Point-To-Point Connection Environment Settings] Window; Table 3.2 Input Items For The [Point-To-Point Connection Environment Settings] Window - Fujitsu Primequest 2000 Series Installation Manual

CHAPTER 3 REMCS Service Start Procedure
3.2 REMCS Center Registration
When the connection configuration is [P-P Connection(ISDN: Mail Only)] or [P-P
Connection(VPN:Mail Only)]
If you selected [P-P Connection(ISDN: Mail Only)] or [P-P Connection(VPN: Mail Only)] in the window shown
in FIGURE 3.4 [Initial Settings]
environment settings] window
After setting the REMCS service, you can still change the connection information by clicking [Connection
Environment] from the menu in the window shown in
1. Enter the values for the following items.

TABLE 3.2 Input items for the [Point-to-Point Connection environment settings] window

Item
SMTP/PROXY Server
Sender E-mail Address
Division method
Division Size
Encryption type
2. Click the [Next] button.
After the connection configuration is registered, the window shown in
Connection settings] window

3.2.4 Setting the periodic connection schedule

In the window shown in
connection schedule.
After starting the REMCS service, you can still change the periodic connection schedule by clicking
[Periodical Connection] from the menu in the window shown in
window, the window shown in
appears.

FIGURE 3.6 [Point-to-Point Connection environment settings] window

Enter the SMTP/PROXY server name or IP address in single-byte
alphanumeric characters and symbols.
Enter the sender e-mail address in single-byte alphanumeric
characters and symbols.
Select the division method from [No division], [Mail division], and
[Event division]. The initial value is [Event division].
Enter the partitioning size in the range of 10 to 100 Kbytes. The
initial value is 64 Kbytes.
If the S/MIME format is not supported before the firmware update,
the initial value is [Previous encryption]. The initial value at the
firmware update time is the setting before the firmware update.
appears. Proceed to
FIGURE 3.7 [Periodical Connection settings]
FIGURE 3.6 [Point-to-Point Connection
FIGURE 4.1 [REMCS initial]
Description
3.2.4 Setting the periodic connection
window, specify the periodic
FIGURE 4.1 [REMCS initial]
13
window.
FIGURE 3.7 [Periodical
schedule.
window.
CA92344-0542-02