Setting Auto Surround - JVC LVT0858-001A Instructions Manual

Basic Settings
STANDBY
STANDBY/ON
PHONES
SETTING
2
Press CONTROL∞ (or 5) repeatedly until
"D.COMP (Dynamic Range Compression)"
(with the current setting)
CONTROL
Ι
R
TT
* "MID" is the initial setting. If you have already changed the
setting, another setting will be shown.
3
Press CONTROL 3 (or 2) to select the
appropriate compression level.
• Each time you press the button, the compression level changes
as follows:
CONTROL
PR ΙΙ
ANALOG L C R
LPCM DSP
SUBWFR LFE
AUTO SR
DOLBY D
LS S RS
DTS INPUT ATT
OFF : Select this when you want to enjoy surround with its
full dynamic range. (No effect applied.)
MID : Select this when you want to reduce the dynamic range
a little.
MAX : Select this when you want to apply the compression
effect fully. (Useful at night.)
Note:
The result from compressing dynamic range differs for each source.
18
CONTROL
5/∞/3/2
Display
TV DIRECT
DVD STB
CONTROL
ANALOG L C R
LPCM DSP
SUBWFR LFE
DOLBY D AUTO SR
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD STB
appears on the display.
*
VOL
VOL
HOME CINEMA CONTROL CENTER
VCR TV TAPE FM/AM
PL ΙΙ AUTO MUTING
SLEEP AUTO MODE TA HEWS INFO RDS TUNED ST
HP
MH
Z
KH
Z INPUT
VOL
ANALOG/DIGITAL
INPUT ATT
VCR TV TAPE FM/AM

Setting Auto Surround

Surround mode is automatically activated when a multichannel
signal comes into this unit through the digital terminal.
You can enjoy Surround mode simply by selecting the source (with
digital input selected for that source)—Auto Surround.
To activate Auto Surround, follow the procedure below.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
SETTING
2
Press CONTROL ∞ (or 5) repeatedly until
"AUTO SR (Auto Surround)" (with the current
setting) appears on the display.
*
CONTROL
PR ΙΙ
SP
UTO SR
PUT ATT
* "OFF" is the initial setting. If you have already changed the
setting, "ON" will be shown.
3
Press CONTROL 3 (or 2) to select "ON" (or
"OFF").
• Each time you press the button, Auto Surround turns "ON" or
"OFF."
CONTROL
PR ΙΙ
ANALOG L C R
LPCM DSP
SUBWFR LFE
DOLBY D AUTO SR
LS S RS
DTS INPUT ATT
SURROUND SURROUND
ON/OFF MODE
MASTER VOLUME
Remote
NOT
VOL
VOL