REMOVE
Use always the [MENU/ ] and [ ] keys, located on the control panel, to select among the
printer Menu functions and then press ENTER and CANCEL to confirm or cancel the
execution of a function.
2.1.2 Data receiving Display Messages
If from the driver you set the function of data check the LCD display will visualize the
following message
2.2 POWER SUPPLY CABLE CONNECTION
Make sure that the printer power switch is off (0).
1) Connect the power cord to the power cord socket on the rear of the printer.
2) Plug the other end of the power cord into the power outlet (100V to 240V AC).
Power
Take care to follow carefully the safety instructions set forth in 1.3.
Don't connect the printer to a power source that provides other than the rated voltage (100V to
240V AC, 50/60Hz). Using any other voltage could cause a fire or electric shock.
Don't pull the power cord when it is connected to the power cord socket on the rear of the
printer or otherwise apply undue force to the power cord connector. Doing so could damage
the wiring and cause a short, fire, or electric shock.
When unplugging the power cord from the power outlet or the socket on the rear of the printer,
always grasp the plug or connector.
2.3 USB CABLE CONNECTION
Make sure that you are using an USB interface cable compatible with your PC.
1) Connect the USB cable on the rear of the printer.
2) Connect the other end of the USB cable on the PC
The HTP500 V2 Printer is supplied with one USB Port (A to B)
to clear a jam or to eject a printer media
REMIND
WARNING
REMIND
USB port