Daily Care - ABB HTP500 User Manual

One of the printer components may be damaged. Ask ABB Technical Assistance.
To clear this message from the printer display, turn the printer power off and wait at least
three seconds before turning on the printer again.
If the message doesn't disappear from the display, even if the power is turned off and back
on again, turn the power off, unplug the printer and contact the ABB Technical Assistance

7.4 DAILY CARE

A careful daily care helps to keep HTP500 V2 in good condition and achieving best print
performances.
7.4.1 CLEANING THE CLEANING ROLLER
Cleaning Function
The printer is equipped with a cleaning roller that cleans dust and dirt off the plates before
printing.
1) Press Online to set the printer offline. The online led turns off.
2) Press [Menu/ ] to select Cleaning.
3) Press Enter to confirm and start up cleaning the roller. Now Cleaning message appears on
the display.
Sometimes the Auto Clean mode is recommended, it depends on how the printer is being
used.
Cleaning (Maintenance)
Clean the cleaning roller regularly.
1) Turn off the printer. Open the cover cassette, then remove the cleaning cassette and the
ribbon.
2) Grasp the shaft of the cleaning roller, lift it upwards to the right and remove it gently.
3) Clean the roller using a soft, damp cloth and taking good care not to scratch it.
4) Once the roller surface is completely dry, install the roller back into the printer.
This printer has an automatic cleaning function.
In case the automatic cleaning function should not clean enough, remove the roller and clean it
REMIND
NOTICE
REMIND
NOTICE