Setting Up The Module; Connecting The Module - HP Jetdirect pn1050 Setup Manual

Setting Up the Module

Connecting the Module

1. Make sure the projector is set up and operating normally.
2. Plug a LAN cable into the server module. The LAN cable must be
connected to a 10Base-T or 100Base-TX Ethernet local area network.
3. Plug the USB cable into the server module and the projector. The wide
connector plugs into the module, and the narrow connector plugs into the
projector.
Note
Do not connect the USB cable to any USB hub, converter,
or extender.
Installing the HP Jetdirect Module 6