Mounting The Module (Optional) - HP Jetdirect pn1050 Setup Manual

Mounting the Module (Optional)

You can mount the server module on the projector or on any nearby smooth,
clean surface. The attachment strips separate to allow you to remove the
module temporarily.
1. Decide where to mount the server module on the projector or other surface:
■ Make sure the mounting surface is flat, smooth, and clean.
■ Do not block any vents, controls, or access panels on the projector.
■ Make sure the cables from the module do not interfere with controls or
access panels on the projector.
2. Peel the backing paper off one side of an attachment strip.
Note
3. Attach the strip along the top or bottom edge of the label on the bottom
of the server module. Press firmly to get full adhesion.
Note
4. Attach the other strip to the opposite edge of the label as described above.
5. Clean the projector or other surface where you intend to mount the
module.
Do not separate the two halves of the strip.
Do not cover the module's serial number.
Installing the HP Jetdirect Module 8