HP Jetdirect pn1050 Setup Manual page 9

6. Peel the backing paper from the exposed sides of the two attachment strips.
7. Press the module firmly onto the mounting surface so that the attachment
strips adhere properly.
To remove the module, gently pull it away from its mounting surface so that
the halves of the attachment strips separate. To reattach the module, press it
back into place so that the strips reattach.
Note
As an alternative, you can mount the module to a wall or
other solid surface using the two keyhole slots in the bottom
of the module. Insert two screws into the surface 33 mm
(1–5/16 in) apart, then slide the keyhole slots over the heads
of the screws.
Installing the HP Jetdirect Module 9