Panasonic SJ-MR200 Service Manual page 19

staticelectricity generated in your clothes or body. Be especially
careful with the static electricity.
6.2.2.2. Adjustment Procedure
1. Have " T1 EX " indicated on display, and move the optical pickup
to the most inside (only when a MD cartridge type laser power
meter is used).
2. Uncover the laser power meter. (as shown in
3. Locate the sensor of the laser power meter at a position above
the optical pickup (horizontally at a level of the disc position). (as
shown in Fig. 7
4. Press the PLAY key of the remote controller (" T1 EX " changes to
" LD " of the LCD).
5. Press the
" of the LCD).
6. Perform the read power adjustment. Set the light power at 600
±10% by using VOL+ and VOL- key of the remote controller.
Caution:
Proceeding on to the subsequent adjustment procedure with the
read power exceeding 600
optical pickup.
7. Press the
)
key of the remote controller (" LD " changes to " LP
key of the remote controller (" LP " changes to "
Fig. 6
Fig. 7
W±10% will result in damage to the
19
Fig. 6 )
W