Table of Contents
Advertisement
OFF, press the VOL+, VOL-,
controller within two seconds. (as shown in
3. When entering the main unit's key check mode, " KEY EX " will be
displayed on the LCD of main unit and " T KEX " will be displayed
on the LCD of remote controller. (If it is notdisplayed, perform the
procedures written above again.)
4. Confirm the display of LCD by pressing any keys on the main unit.
There is no order to press the keys.
Mian unit's keys LCD display positions and letters
HOLD OFF
REC PAUSE
EDIT
STOP
PLAY
5. Remote controller's LCD lights " T
lights all when you can detect all keys.
6. Perform below voltage check about the keys come under if you
cannot detect the key.
Main unit's keys
HOLD
REC PAUSE
EDIT
STOP
PLAY
7. When the keys are ready for detection, press the PLAY key of the
remote control.
8. Pressing each key mounted to the main body, make sure of
displayed three letters (4th ~ 6th letters) on the right side of the
remote control. / Keys to be pressed are not in order. / When the
3 keys apportioned to the respective letters asshown below are all
OK, " 0 " is displayed.
1st. 2nd. letters are AA
3rd. 4th. letters are BB
5th. 6th. letters are CC
7th. 8th. letters are DD
9th. 10th. letters are EE
Check points
IC501 55pin
IC501 49pin
IC501 3pin
IC501 3pin
IC501 48pin
, and
buttonson the remote
" and main unit's LCD
ON
OFF
0V
2.4V
0V
2.4V
1.94V
2.4V
0V
2.4V
0V
2.4V
22
Fig. 5
)
- Quick Links:
- Operating Instructions
Hide quick links:
Advertisement
Table of Contents
