Installing Your New Vcr; Basic Connections - JVC SR-VS30U Instructions Manual

Filename [VS30U_1-EN.fm]
VS30U_1-EN.fm Page 12 Thursday, January 31, 2002 3:33 PM
12
EN

Basic Connections

Matching Transformer
(not supplied)
VIDEO
OUT
ANTENNA
IN
ANTENNA
OUT
Audio/Video Cable
To Audio/Video
Input Connectors
RF Cable
(supplied)
To 75 ohm Terminal
Page 12
Antenna or Cable
Coaxial Cable
Flat Feeder
AC Outlet
AUDIO
AC
OUT
Power
Cord
Back of VCR
(supplied)
TV

INSTALLING YOUR NEW VCR

It's essential that your VCR be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
A
Check the contents.
Make sure the package contains all of the accessories
listed in "SPECIFICATIONS" on page 82.
B
Situate the VCR.
Place the VCR on a stable, horizontal surface.
C
Connect the VCR to TV.
A Disconnect the TV antenna from the TV.
B Connect the TV antenna cable to the ANTENNA IN
connector on the rear panel of the VCR.
C Connect the supplied RF cable between the
ANTENNA OUT connector on the rear panel of the
VCR and the TV's antenna terminal.
D Connect the supplied Audio/Video cable between the
AUDIO/VIDEO OUT connectors on the rear of the
VCR and the Audio/Video input connectors on the TV.
Set your TV to AV mode.
For switching the TV's mode, refer to the instruction manual of
your television.
To obtain high-quality S-VHS pictures, you can also use the
S-VIDEO connection described on page 13.
D
Connect the VCR to power source.
Plug the end of the AC power cord into an AC outlet.
The clock and tuner channels will automatically be set when
the antenna is connected and when the AC power cord is first
connected to an AC outlet (
displayed on the front display panel before the VCR is
powered on, the clock and tuner channels are being set
automatically. Wait for the time to be displayed on the front
display panel before turning on the VCR.)
Masterpage:Left
pg. 14). (If "Auto" or "CH" is
January 31, 2002 3:21 pm