Setting Cable Box's Brand And Channel - JVC SR-VS30U Instructions Manual

Filename [VS30U_1a-EN.fm]
VS30U_1a-EN.fm Page 21 Thursday, January 31, 2002 3:35 PM
T
1
4
7
1

Setting cable box's brand and channel

After installation, set the cable box's brand and channel
correctly; otherwise, the Controller cannot work
correctly.
Turn on the TV and select the AV mode.
A
Turn on the VCR.
Press POWER.
B
Turn on the cable box.
Turn on the cable box's power.
C
Access the Main Menu screen on the VCR.
Press MENU.
Page 21
W
2 3
2
5 6
8 9
0
4
DV S-VHS
D
Access the Initial Set screen.
Press to move the
rt
highlight bar (arrow) to
"INITIAL SET", then press OK
or .
e
E
Access the Cable Box Set screen.
Press to move the
rt
highlight bar (arrow) to
"CABLE BOX SET", then
press OK or .
e
F
Select the cable box's channel.
Your selection depends on how
the cable box is connected to
your VCR.
If the cable box is connected
to your VCR's ANTENNA IN
connector on the rear panel,
press until the channel
rt
number representing the cable
box's output (CH2 – CH9) appears on the screen.
If the cable box is connected to your VCR's AUDIO/
VIDEO IN connectors on the rear panel, press
"ON L-1 (REAR)" appears on the screen.
If you do not use a cable box, press
appears on the screen.
Masterpage:Right-NoTitle0
21
EN
until
rt
until "OFF"
rt
January 31, 2002 3:35 pm