24Hr Quick Programing - JVC SR-VS30U Instructions Manual

Filename [VS30U_2-EN.fm]
VS30U_2-EN.fm Page 48 Thursday, January 31, 2002 3:38 PM
48
EN
24HR Quick
Programing
Before performing the 24HR Quick Programing:
Make sure that the VCR's built-in clock is set properly.
Select the deck.
Set the tape speed.
For the VHS deck:
Insert a VHS (or S-VHS) cassette with the record safety tab
intact.
For the DV deck:
Insert a Mini DV cassette with the erase protection switch
set to "REC".
Page 48
You can program a timer recording that starts within 24
hours using the ADVANCED JOG dial on the VCR.
A
Press 24HR QUICK PROGRAM on the VCR. The start
time indicator (
panel.
B
Turn the ADVANCED JOG dial to the left or right to set
the time you want recording to start.
One click stop of the ADVANCED JOG dial changes the time
in 5-minute intervals.
Push the ADVANCED JOG dial. The stop time indicator
( ) starts blinking on the front display panel. Turn the
ADVANCED JOG dial to the left or right to set the time
you want recording to stop.
1 3 2
Push the ADVANCED JOG dial. Turn the ADVANCED
JOG dial to the left or right to select the channel you wish
to record.
You can cancel the setting at any time by pressing and holding
the ADVANCED JOG dial for more than 3 seconds or pressing
CANCEL on the Remote. Repeat the step 2.
C
Press 24HR QUICK PROGRAM. The VCR turns off
automatically and "
panel.
To disengage the timer mode, press TIMER or 24HR QUICK
PROGRAM again.
TIMER RECORDING (cont.)
Enter the program mode.
) starts blinking on the front display
Set the program start/stop time and
channel.
Engage the VCR's timer mode.
" appears on the front display
#
January 31, 2002 3:37 pm
Masterpage:Left