Safety In Hospitals; Rf Exposure Guidelines; Safety Information; Remote And Standalone Antenna Configurations - Motorola AP-5131 Installation Manual

Table of Contents

AP-5131 Access Point: Installation Guide

Safety in Hospitals

Wireless devices transmit radio frequency energy and may affect medical electrical equipment. When installed adjacent to

other equipment, it is advised to verify that the adjacent equipment is not adversely affected.

The device complies with Internationally recognized standards covering human exposure to electromagnetic fields from

radio devices.

Reducing RF Exposure—Use Properly

Only operate the device in accordance with the instructions supplied.

To comply with FCC RF exposure requirements, antennas that are mounted externally at remote locations or operating near

users at stand-alone desktop of similar configurations must operate with a minimum separation distance of 20 cm from all

persons.

Use only a Motorola approved power supply output rated at 48Vdc and minimum 0.25A. The power supply shall be Listed

to UL/CSA 60950-1; and certified to IEC60950-1 and EN60950-1 with SELV outputs.

The AP5131 can also be powered from a 802.3af compliant power source.

Use only a Motorola approved power supply. Use of alternative power supply will invalidate any approval given to this

device and may be dangerous.

Wireless Devices - Countries

Select only the country in which you are using the device. Any other selection will make the operation of this device illegal.

The use on UNII (Unlicensed National Information Infrastructure) Band 1 5150-5250 MHz is restricted to indoor use only, any

other use will make the operation of this device illegal.

The available channels for 802.11 b/g operation in the US are Channels 1 to 11. The range of channels is limited by firmware.

Table of Contents

Show Quick Links

Table of Contents