Charging And Using The Battery - Siemens HiPath 4000 Operating Instructions Manual

Charging and using the battery

To charge the battery, insert the handset into the charging shell with the
keypad facing forwards.
Important:
Only use the relevant approved power supply units for operating
the charging shell (for order numbers see
The charging status is indicated by the charge status display:
{ lighting white: charged over 66%
{ lighting white: charged between 34% and 66%
y lighting white: charged between 11% and 33%
y lighting red: charged below 11%
y flashing red: battery almost empty (less than 10 minutes talktime)
xy xy x{ x{
Note:
• Initial charging: Charge the battery for at least 3 hours without
a break, regardless of the charging status icon. Without replac-
ing it in the charging shell, use the handset until the "battery
low" beep is heard. This action aligns the charge status display
with the operating times of the battery.
• To attain full operating and charging times: After charging, re-
move the handset from the charger and only replace it when
the battery is fully discharged.
• For future charging: you can replace your handset in the charg-
ing shell each time it has been used. Charging is electronically
controlled which ensures that the battery is charged optimally.
Putting the handset into service
Page 122).
lighting white: battery being charged
17