Fujitsu Stylistic 3400 Technical Reference Manual page 24

Table 3-4. Serial/Parallel Port Configurations Submenu Options (Continued)
Option
DMA Channel
Parallel Port
Mode
I/O Address
Interrupt
DMA Channel
11 Configuring the Stylistic 3400 Pen Tablet System
Settings
DMA 1
DMA 3
Disabled
Enabled
Auto
Output Only
Bidirectional
ECP
378 - 37F
278 - 27F
3BC - 3BF
IRQ 3
IRQ 4
IRQ 7
DMA 1
DMA 3
Description
Determines the DMA channel assigned to the
infrared port when using Fast IR mode. This option is
only selectable when the Infrared Port Mode setting
is FIR.
Determines how system resources for the parallel
port are configured.
Select [Enabled] to configure resources manually.
Select [Auto] to allow the BIOS (or Plug and Play
operating system) to configure system resources for
the parallel port.
Select [Disabled] to disable the parallel port.
Determines the operational mode for the parallel
port. Select Output Only, Bidirectional, or ECP
(Extended Capabilities Port) depending on which
setting is appropriate for your application.
This option is not displayed when the Parallel Port
option is set to [Disabled].
Determines the base I/O address used for the
parallel port. This option is not displayed when the
Parallel Port option is set to [Disabled].
Determines the interrupt request level used for the
parallel port. This option is not displayed when the
Parallel Port option is set to [Disabled].
Determines the DMA channel assigned to the
parallel port when using ECP mode.
This option is only displayed when the Parallel Port
option is set to ECP.