Charging And Using The Batteries - Siemens HiPath 4000 User Manual

Putting the Handset into Operation

Charging and using the batteries

To charge the batteries, insert the handset into the charging shell with the
keypad facing forwards.
The charging status is indicated by the charge status display. This flashes
during charging:
=
e
V
U
16
Attention:
Only use the relevant approved power supply units for operating
the charging shell (for order numbers see
Battery flat
Battery 33% charged
Battery 66% charged
Battery 100% charged
Note:
• Initial charging: Charge the batteries for at least 10 hours with-
out a break, regardless of the charging status icon. Without re-
placing it in the charging shell, use the handset until the "bat-
tery low" beep is heard. This action aligns the charge status
display with the operating times of the batteries.
• To attain full operating and charging times
replacing it in the charging shell, use the handset until the "bat-
tery low" beep is heard.
• For future charging: you can place your handset in the charging
shell each time it is used. Charging is electronically controlled
which ensures that the batteries are charged optimally.
Page 117).
Page 17: Without