Toshiba digital copiers Service Manual page 33

3
GA-1121 board
T GA-1121
O REMOVE THE
1. Remove the GA-1121 assembly as described on page 3-4.
2. Open the GA-1121 assembly as described in page 3-5.
3. Remove cables connected to the GA-1121 board:
• HDD cable at J920
• HDD power cable at J911
• Power supply cable at J918
• Control Panel cable at J919
• Intake fan 1 cable at J353
• Intake fan 2 cable at J352
4. Remove the hard disk drive as described on page 3-19.
5. Remove the 7 screws that secure the board to bottom of the tray.
6. Carefully lift the board out of the tray.
To avoid damage to components on the back of the board, first lift the board straight up
before lifting it away from the closed end of the tray.
BOARD
3-9