Configuring The Wireless Switch From The Default Configuration - Motorola WS 2000 Configuration Manual

Configuring the Wireless Switch from
the Default Configuration
8
Radio settings: The SpectraLink Wireless Telephones use an
802.11b radio; therefore VIEW Certification testing was done with
the 802.11b mode only and not the b/g mode.
Commands
Beacon-interval
DTIM-period
BG mode
Power level
Channel
Rates
Short preamble
* Denotes settings that are required for operation with SpectraLink Wireless
Telephones
Configuring radio settings through the CLI
To configure radio settings for the wireless switch, use the following
commands.
admin>
admin>network
admin(network)>ap
admin(network.ap)>
admin(network.ap)>set beacon intvl
admin(network.ap)>set dtim 1 3
admin(network.ap)>set rate 1 1,2,5.5,11 1,2,5.5,11
Setting the channel
Regulatory parameter values depend on country of operation and
radio type. Refer to documentation for regulatory product
information.
Default Settings
100
10
B and G
20 dBm
1
1, 2, 5.5, 11
Disabled
1 100
Configuration Guide
VIEW Tested Settings
100 *
3 *
B only *
20 dBm
1
1, 2, 5.5, 11
Disabled *
PN: 1725-36066-001_D.doc