Hitachi AJ-S55GZ User Manual page 55

4
Fit the angle hole of the filter net
o v e r t h e c o n v e x i t y o f t h e
encasing, then match the hasps
on left and right sides. (push the
protrusion of the angle hole into
the encasing)
(
)
Angle hole Convexity
Hasp
Protrusion
Net pull down
When icing is possibly underway
1
Turn off the tap, and disassemble
the water supply hose.
(Refer to page 12 for proper dis-
assembly)
12
2 Make the water supply hose
downward, but don't bend it.
• Lest the water remained in the
charging hose will flow out.
3
Select the "BASKET CLEAN" process, and the opera-
tion will stop after 30 minutes.
• All the water remained in the charging hose can be drained.
4 Put down the water drainage hose.
5
Only set the "Spinning", and the operation lasts for
about 30 seconds. 40
30
6 Switch off the power.
• In order to drain the water remained in the basket and
water drainage hose, charging valve shall be kept
open.
5
Install the lint filter.
Kacha
1 Insert the lower hasp of the encasing in.
2 Press the enchasing until hearing the
sound of "Kacha".
Turn off
1
Water
supply hose
30
40
Notes
• The lint filter is consumable items.
When damage is found in the fiter net,please
buy a new one at a dealer.
Attention
Hasp
• When the lint filter is fetched out, please do
not let the coin or barrette fall in the bottom of
the washing basket.
• Please do not wash clothes after removing the
lint filter lest it will damage the clothes.
• If lint filter is wrongly installed, the clothes or
filter may be damaged during washing.
When icing happens
1 Disassemble the water supply hose, and put it into
the warm water as hot as 40
40
2
Pour the warm water as hot as 40
40
3
Connect the water supply hose to the tap, and check
the washing machine to make sure the water supply
and drain are in normal case.
o
C.
o
C into the basket.
55