Hp Stack Manager Advanced Features - HP J2415A Installation And Reference Manual

Advancestack 100vg hub-14
Table of Contents

Advertisement

Installing and Using HP Stack Manager
you will have to press the [Connect] button in the HP Stack Manager main
screen to re-establish the connection to access the hub or chain of hubs.
If you reset one of the other hubs in the chain (not the one to which the PC
is physically connected), the HP Stack Manager session will continue but
access to that hub will be lost until the reset process completes on that hub.
Occasionally, HP Stack Manager may not be able to automatically relocate
the hub and you will not be able to re-establish access to that hub even
though it may still be visible in the device chain list. In that case, press the
[Refresh] button on the Hp Stack Manager main screen and the entire list of
hubs will be quickly rediscovered and access will be restored.

HP Stack Manager Advanced Features

Some additional management features are accessible through HP Stack
Manager when an optional HP J2414B 100VG/ET SNMP/Bridge Module is
installed in the hub. Advanced HP Stack Manager features include the
following:
2-16
Advanced embedded agent code that supports SNMP (Simple Network
Management Protocol) for remote management over the network.
Configuration of IP parameters to allow the hub to be managed from an
SNMP network management station on an Internet Protocol network.
Setting passwords to protect access to the hub through the RS-232
console port or SNMP-based network management stations.
Setting Authorized Managers (SNMP-based network management
stations) that can access the hub and will receive traps from the hub.
Performing Network Tests for troubleshooting network communication
problems.
Viewing 10:100 and 100:10 bridge counters for monitoring bridge module
operations. The display of selected bridge counters will be selectable
through the "Counter Group" selection list in the Counters window.
Performing a Factory Reset to reconfigure the hub to its original factory
configuration settings.
Enable or disable bridging and set bridge address aging time.

Advertisement

Table of Contents
loading

Table of Contents