Tuner Mode - Sanyo DMP-P1 Instruction Manual

1. Press the SLEEP / CLOCK SET button to select the sleep time in operation mode.
2. The sleep time cycles by pressing the SLEEP / CLOCK SET button
repeatedly. The cycle goes 120 -> 90 -> 60 -> 30 -> 15 -> 10 -> 5 ->
off. Select "OFF" means no sleep function.
3. After the SLEEP mode is activated, press the SLEEP / CLOCK SET button to display the
remaining time before STANDBY mode is activated.
4. Further pressing the SLEEP / CLOCK SET button to set another sleep time.

TUNER MODE

Radio Antenna
The FM antenna is located at the back of the unit. If FM reception signal is weak, extend the
FM antenna to its full length or try to change the position and direction of the FM antenna until
you find the strongest signal.
The AM bar antenna is installed inside the unit. If AM reception is weak, change the position
and direction of the unit until the internal antenna picks up the strongest signal.
Listening to Radio
1. Press STANDBY/ON/FUNCTION to turn on the unit, and then select the FM or AM
function by pressing the STANDBY/ON/FUNCTION button.
2. Tune to the desired radio station by pressing the TUNE/SKIP
3. Press and hold the TUNE/SKIP
strong signal is found.
4. To turn off the radio, press and hold the STANDBY/ON/FUNCTION button to switch the
unit to standby mode.
Tuning and Storing Radio Stations
This device can store up to 10 preset stations for FM and 10 preset stations for AM.
1. In FM or AM mode, tune to the desired radio station.
2. Press and hold the MEMORY/ALARM SET button until the preset
channel begin to flash to enter memory mode.
3. Choose the desired channel to store in by pressing the TUNE/SKIP
press the MEMORY/ALARM SET button to confirm and store the radio station.
4. Repeat steps 1 – 3 to store more stations.
or button will begin to automatically scan until a
11
or button.
or button,