Triggerless Strap Holder Replacement - Motorola RS507 Quick Reference Manual

22
Installation
Turn the Imager upside-down.
1.
Position the Trigger Swivel Assembly to align with
2.
the back of the Imager.
Lower the Trigger Swivel Assembly to the Imager.
3.
Rotate Trigger Swivel Assembly 1/4 turn
4.
counterclockwise.
Press the Comfort Pad onto the Imager. When
5.
properly installed, the Comfort Pad "locks" into
place.
Note: An optional Triggerless Strap Holder should be installed when the
Imager is intended to be used in Motion and Proximity Initiated Bar code Read
mode.

Triggerless Strap Holder Replacement

Removal
Turn the Imager upside-down.
1.
Remove the Comfort Pad.
2.
Use a paper clip or similar object
3.
to press the Release Latch.
Rotate the Triggerless Strap
4.
Holder to align with the back of
the Imager.
Lift the Triggerless Strap Holder
5.
off the Imager.
RS507 Hands-Free Imager
2
Triggerless
Strap Holder
2
3
Imager Back
Release Latch
1
1