Triggerless Strap Holder Replacement - Motorola RS507-IM2xxxxSTWR Product Reference Manual

3 - 6 RS507 Hands-Free Imager Product Reference Guide

Triggerless Strap Holder Replacement

NOTE The Triggerless Strap Holder should be installed when the Imager is intended to be used in Motion and
Proximity Initiated bar code read mode.
Removal
To remove the Triggerless Strap Holder:
Turn the Imager upside-down.
1.
Remove the Comfort Pad.
2.
Use a paper clip or similar object to press the Release Latch.
3.
2
Release Latch
Removal of Triggerless Strap Holder
Figure 3-5
Rotate the Triggerless Strap Holder to align with the back of the Imager.
4.
Lift the Triggerless Strap Holder off the Imager.
5.
Installation
To install the Triggerless Strap Holder:
Position the Triggerless Strap Holder to align with the back of the Imager.
1.
2
1
Turn the Imager upside-down.Installation of Triggerless Strap Holder
Figure 3-6
3
Imager Back
Triggerless Strap Holder
1
Triggerless Strap Holder