Rsmsample Application - Motorola RS507-IM2xxxxSTWR Product Reference Manual

Use the > < keys to select scanner. Select SCN1 for corded Imager or SCN2 for cordless Imager (Bluetooth).
3.
NOTE Before you select SCN2 make sure to pair and connect the Imager to the mobile computer.
Select Reader Params...
4.
Reader Params...
Figure 4-3
Use the > < keys to change the Picklist Mode to Enable and press the OK button.
5.
Picklist Mode
Figure 4-4
This setting is retained until cold boot is performed to the mobile computer or new setting is entered through
the Control Panel application.
Re-start your scan application and verify that Picklist Mode is enabled.
6.

RSMSample Application

The Remote Scanner Management Sample (RSMSample) application is used for configuring the Imager by
changing its attribute values. The RSMSample application also enables one to retrieve and display the current
setting of each attribute. Users with mobile computer that do not have the RSMSample application installed can
download the application and related documentation from the Support Central site at:
http://www.motorola.com/enterprisemobility/contactsupport.
NOTE When the Imager is connected to a mobile computer, configuration by scanning bar codes is disabled. In
such case, the Imager configuration is performed by the application (e.g RSMSamplen) running on the
mobile computer. The new configuration overrides the previous configuration. The new configuration is
saved in the Imager memory after disconnecting the Imager from the mobile computer or terminating the
application.
RS507 Update and Configuration 4 - 3