Table of Contents
Advertisement
Chapter 5 Miscellaneous Imager Options
Introduction
The Imager is intended to operate hand in hand with the mobile computer to which it is connected.
The mobile computer automatically loads configuration data whenever connected to an Imager (corded or
cordless). This operation does not require scanning configuration bar codes. Using configuration bar codes is only
available for a cordless Imager when decontrolled from the mobile computer.
It is recommended to use configuration bar codes only for setting parameters that cannot be configured by the
other mobile computer application.
Imager parameters set by scanning configuration bar codes, persist in the Imagers memory.
NOTE
The Imager ships with the settings shown in
Parameters
for host device and miscellaneous defaults). If the default values suit the requirements, programming
is not necessary.
NOTE Most computer monitors allow scanning the bar codes directly on the screen (when using the imaging
engine). When scanning from the screen, be sure to set the document magnification to a level where you
can see the bar code clearly, and bars and/or spaces are not merging.
To return all features to default values, scan the
bar code menus, asterisks indicate (
Table 5-1 on page 5-2
Set Default Parameter on page
*
) default values.
*
*
High Volume
Indicates Default
(also see
Appendix A, Standard Default
Feature/Option
(00h)
Option Hex Value for
programming via SSI
command
5-4. Throughout the programming
Hide quick links:
Advertisement
Table of Contents
