Switching Between Ssi (Scan), Hid And Spp - Motorola RS507-IM2xxxxSTWR Product Reference Manual

7 - 36 RS507 Product Reference Guide
Perform a Cold Boot by removing and re-installing the battery onto the RS507. The RS507 starts to operate
3.
under SSI (SCAN) for connection to Motorola terminals.

Switching between SSI (SCAN), HID and SPP

To switch the RS507 from one mode to another:
Perform Clean Boot to the RS507:
1.
•
Remove the battery from the RS507.
•
Press and hold the Restore key.
•
Install the Battery onto the RS507.
•
Keep holding the Restore key pressed for about five seconds until a chirp is heard and the Scan LEDs flash
green.
Scan the required profile bar code (see the following bar codes).
2.
SPP bar code
HID bar code
Perform a Cold Boot by removing and re-installing the battery onto the RS507 (see
3.
The RS507 starts to operate and is also discoverable as a keyboard (HID) or serial device (SPP).
IMPORTANT In Win 7 SP1, when switching between SPP connection and HID connection and vice versa, the RS507 device
must be removed from the computer pairing list.
SSI (SCAN) bar code
Cold Boot on page 7-3).