Kenwood KVT-920DVD Instruction Manual page 58

Installation
Installation for Receiver unit
Securing to audio board
1
Attach the installation brackets to the sides of the
hideaway unit using the sems bolts (M4 ´ 8 mm).
Installation brackets
(Accessory K)
Securing to pile carpet
Peel the protective strips off of the velcro strips, attach them to the bottom
of the hideaway unit, and secure to the pile carpet.
2CAUTION
Please do not install the unit near the dashboard, the rear tray, or other
important components. Doing so could lead to injury or accident should
the unit come off due to a shock and strike a person or an important
component.
Tapping screws should be used for mounting. (Attachment with velcro
strips, although easy, can come off with a shock.)
Removing Monitor Unit
Removing the Hard Rubber Frame
1
Engage the catch pins on the removal tool and
remove the two locks on the lower level.
Lower the frame and pull it forward as shown in the
figure.
Accessory J
Removing the Unit
1
Refer to the section "Removing the Hard Rubber Frame" and then remove
the hard rubber frame.
2
Remove the Hex-head screw with integral washer (M4´6) on the back panel.
3
Insert the two removal tools deeply into the slots on each side, as shown.
4
Lower the removal tool toward the bottom, and pull out the unit halfway
while pressing towards the inside.
2 CAUTION
Be careful to avoid injury from the catch pins on the removal tool.
5
Pull the unit all the way out with your hands, being careful not to drop it.
58
Sems bolts (M4 ´ 8 mm)
(Accessory M)
Catch
Lock
2 Use the tapping screw (ø4 ´ 16 mm) to
secure the hideaway unit to the audio board.
Velcro strips
2
When the lower level is removed, remove the upper
two locations.
NOTE
The frame can be removed from the top side in the
same manner.
(ø4 ´ 16 mm) (Accessory N)
(Accessory L)
Catch facing up