Kenwood KVT-920DVD Instruction Manual page 67

External disc control mode
PROBLEM
The disc control mode cannot
be selected.
The specified disc does not
play, but another one plays
instead.
The sound skips.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track does not
play.
Track repeat, disc repeat, track
scan, random play, and
magazine random play start by
themselves.
Cannot play CD-R or CD-RW
The following messages are displayed when certain problems are occurring in your system.
Take the recommended actions.
More than two center units are connected.
BUS-E50
More than two DSP/EQUALIZER units are connected.
BUS-E11
The protective circuit in the unit activates when the temperature inside the unit exceeds 60°C (140°F),
Hot Error
stopping all operation.
] Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls
below 60°C (140°F), the disc will start playing again.
The disc player is malfunctioning.
Mecha Error
] Eject the disc and try inserting it again. Contact the Kenwood dealer if this indicator continues blinking or
the disc cannot be ejected.
The unplayable discs is inserted
Disc Error
The disc is upside-down.
Read Error
] Load the disc with the labeled side up.
The disc is quite dirty.
] Clean the disc, referring to the section on "Cleaning discs" (see p. 5).
The DVD software encoded for other region code.
Region code
Error
The parental level is set to high levels.
Parental
level Error
The unit is malfunctioning for some reason.
Error 07
] Press the reset button on the unit. If the "E- ##" code does not disappear, consult your nearest service
Error 17
center.
Error 27
Error 37
Error 47
Error 57
Error 67
POSSIBLE CAUSE
No cable has been connected to the disc
changer input terminal on the unit.
The specified CD is very dirty.
The CD is upside-down.
The disc is loaded in a different slot from that
specified.
The disc is severely scratched.
Something is touching the disc changer.
The CD is scratched or dirty.
The computer chip in the unit is not functioning
normally.
Random play or magazine random play has been
selected.
The setting is not cancelled.
Finalization processing is not being conducted
for CD-R/CD-RW.
A non-compatible CD changer is being used to
play the CD-R/CD-RW.
SOLUTION
Connect the cable to the disc changer
input terminal on the unit.
Clean the CD.
Load the CD with the labelled side up.
Eject the disc magazine and check the
number for the specified disc.
Try another disc instead.
Remove whatever is touching it.
If skipping happens at the same place
when the car is stopped, something is
wrong with the CD. Clean the CD.
Press the reset button on the unit (see
page 4).
Turn off the random play or magazine
random play function.
The settings for these functions remain
on until the setting to off or the disc
ejected, even if the power is turned off
or the source changed.
Conduct finalization processing with CD
recorder.
Use a CD changer compatible with CD-
R/CD-RW to play.
67