Toro Sand Pro 5040 Service Manual page 129

Removal (Fig. 5)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Remove knob from lift lever.
3. Remove four (4) screws and flat washers that secure
control panel to console (Fig. 6). Lift control panel, un-
plug wire harness connector from hour meter and re-
move control panel from machine.
NOTE: Console support plate (item 4) is fastened to
console.
4. Remove three (3) cap screws, lock washers and flat
washers that secure console to frame.
5. Lift console from machine.
Installation (Fig. 5)
1. Position console to machine.
2. Secure console to machine with removed fasteners.
3. Connect wire harness connector to hour meter and
position control panel to console. Secure control panel
with four (4) screws and flat washers (Fig. 6).
4. Install knob to lift lever.
Sand Pro & Infield Pro 3040/5040
7
6
5
4
1. Console
2. Lift lever knob
3. Control panel
4. Flat washer (4 used)
Page 6 – 11
1
3
Figure 6
5. Screw (4 used)
6. Panel decal
7. Hour meter
Chassis
2