Front Wheel Motor - Toro Sand Pro 5040 Service Manual

Front Wheel Motor

45 to 55 ft–lb
(61 to 75 N–m)
2
29
28
27
26
45 to 55 ft–lb
(61 to 75 N–m)
RIGHT
FRONT
1. Wheel motor
2. Lock nut (2 used)
3. Wheel hub
4. Lock nut
5. Spindle
6. Front wheel
7. Lug nut
8. Cap screw
9. Flangette
10. Flangette
11. Bearing
Removal (Fig. 35)
1. Park machine on a level surface, lower attachment,
stop engine, apply parking brake and remove key from
ignition switch.
2. Thoroughly clean hydraulic hose ends and fittings on
wheel motor to prevent hydraulic system contamination.
3. Label hydraulic connections at front wheel motor for
assembly purposes.
Hydraulic System
90 to 120 in–lb
(10.2 to 13.6 N–m)
Loctite #242
8
32
33
10
11
9
8
7
6
200 to 400 ft–lb
(271 to 542 N–m)
12. Flange nut (3 used)
13. Bearing tab
14. Flange nut (2 used)
15. Socket head screw (2 used)
16. Hydraulic fitting
17. Hydraulic tube
18. Hydraulic tube
19. Tube clamp
20. Cover plate
21. Cap screw
22. O–ring
31
30
13
12
14
5
4
3
1
Figure 35
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
Page 4 – 42
24
23
22
22
2
15
22
16
25
22
16
25
23. Hydraulic hose
24. Hydraulic hose
25. O–ring
26. Wheel weight adapter (SP/IP 3040)
27. Wheel weight stud (SP/IP 3040)
28. Wheel weight (SP/IP 3040)
29. Thrust washer (SP/IP 3040)
30. Hose guide
31. Cap screw (2 used)
32. Grease fitting
33. Set screw
WARNING
Sand Pro & Infield Pro 3040/5040
17
18
19
20
21