Toro Sand Pro 5040 Service Manual page 67

5. Remove left rear wheel from machine (see Rear
Wheel Removal in the Service and Repairs section of
Chapter 6 – Chassis).
6. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
7. Thoroughly clean hydraulic hose ends and fittings on
hydraulic tank to prevent hydraulic system contamina-
tion.
8. Label all hydraulic connections on hydraulic tank for
assembly purposes.
9. Disconnect hydraulic hoses from hydraulic tank. Al-
low hoses to drain into a suitable container.
10.Put caps or plugs on disconnected hoses and fittings
to prevent contamination.
11. Remove three (3) tank clamps (items 10 and 12) that
secure hydraulic tank to the frame.
12.Remove hydraulic tank from machine.
13.If hydraulic fittings are to be removed from hydraulic
tank, mark fitting orientation to allow correct assembly.
Remove fittings from tank.
Installation (Fig. 30)
1. If fittings were removed from hydraulic tank, install
fittings with new o–rings to tank using marks made dur-
ing the removal process to properly orientate fittings.
2. Position hydraulic tank to machine frame.
3. Secure hydraulic tank to frame with three (3) tank
clamps (items 10 and 12).
4. Remove caps or plugs from disconnected hydraulic
lines and fittings.
5. Connect hydraulic lines to fittings on hydraulic tank.
Use labels placed during the removal process to proper-
ly install hoses to tank.
6. Install left rear wheel to machine (see Rear Wheel
Installation in the Service and Repairs section of Chap-
ter 6 – Chassis).
7. Install new hydraulic oil filter (see Operator's Manu-
al).
8. Position center shroud to frame and secure with two
(2) cap screws and flat washers (Fig. 31).
9. Fill hydraulic tank with correct hydraulic oil (see Op-
erator's Manual).
Sand Pro & Infield Pro 3040/5040
1. Center shroud
2. Cap screw (2 used)
Page 4 – 39
2
1
3
Figure 31
3. Flat washer (2 used)
Hydraulic System