Motorola AP-5181 Deployment Manual page 26

Hide thumbs Also See for AP-5181:

As an option (not displayed above), the ring seal can be inserted into the receiving threaded hole of the

gland housing. The receiving threaded hole is in the hexagonal section of the gland housing stamped

LTW (see the illustration under step 2). Ensure the ring seal is seated at the bottom of the threaded hole

4. Assemble the gland assembly, finger nut, flange barrel and modular connector onto the cable. You are now

ready to install the connector face gasket.

NOTE

5. Remove the adhesive liner on the gasket. Slide the gasket over the connector and along the cable, with

the adhesive facing the flange surface of the flange barrel.

The modular connector is intended to be wired specifically. It is extremely important to

wire the connector per industry standards for Ethernet, non cross- over configuration).

The applicable standard is TIA/EIA 568-A.

AP5181 Access Point