Setup; Part Names And Functions; Led Indicator; Connections - Panasonic KX-HNB600 Setup Manual

Setup

Part names and functions

A
C D E
G
Speaker

LED indicator

DC jack
LINE jack
MWi-Fi SETUPN
Used when performing initial setup.
microSD card slot
Used when inserting a microSD card.
Remove the label when inserting.
M HANDSET/LOCATORN
Used when registering a handset. You
can also press this button to locate a
misplaced handset.
M CAMERAN
Used when registering a camera.
M OTHER DEVICEN
Used when registering a sensor or smart
plug.
LED indicator
You can use the LED indicator to confirm the
hub's status.
Indicator
Off
10
B
F
H I
Status
No power, or LED
indicator is turned
*1
off
For assistance, please visit www.panasonic.com/support
Indicator
Green, lit
Green, blinking
Alternating:
Green, blinking
Yellow, blinking
Red, lit
Red, blinking quickly
Yellow, lit
Yellow, blinking
Yellow, blinking
quickly
*1 You can configure the hub so that its LED
indicator does not light during normal
operation. For more information, refer to
the User's Guide (page 15).
*2 It may take some time for the hub to finish
starting up.

Connections

Insert the AC adaptor plug firmly into the
DC jack.
Secure the AC adaptor cord by wrapping
it around the hook.
Connect the AC adaptor to the power
outlet.
Insert the telephone line cord into the
LINE jack and a single-line telephone jack
(RJ11C) until you hear a click.
DSL/ADSL service users only: Connect
your DSL/ADSL filter (not supplied).
Outdoor Camera (KX-HNC600) or
Indoor Camera (KX-HNC200) users
only: Remove the label covering the card
slot and then insert the microSD card (not
supplied) into the slot with the notched
1
corner ( ) facing upwards (
clicks into place.
Status
Normal operation,
connected to
*1
wireless router
Registration mode
Hub is starting up
(cannot be used
*2
yet)
Security system is
armed
Security system was
triggered
Initial setup required
Initial setup in
progress, mobile
device connected
Initial setup is
starting
2
) until it