Adjusting The Direction Of Air Circulation; Filter Lamp Reset; Self-Diagnosis - Fujitsu 9373329060 Operating Manual

ADJUSTING THE DIRECTION OF AIR CIRCULATION

Instructions relating to heating are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
Start air conditioner operation before performing this procedure.
To set the operation mode
G Vertical air direction adjustment (Swing operation)
ex. Vertical swing operation
G Horizontal air direction adjustment (Swing operation)
ex. Horizontal swing operation
• Each time the button is pressed, the airflow direction setting changes as shown in MANUAL OPERATION which is included
in INDOOR UNIT.
NOTES
• When using the air conditioner in a room with infants, small children, or elderly or sick persons, the airflow direction and
room temperature should be considered carefully when making the settings.
• The swing operation is not available depending on the model. Please refer to the operating manual for the indoor unit.

FILTER LAMP RESET

Some indoor unit models are equipped with a filter lamp in the indoor unit display to indicate when it is time to clean the air
filters.
Press the Filter button for 2 seconds or more. The indoor unit filter lamp will go off and the filter display will disappear.

SELF-DIAGNOSIS

When "EE" in Temperature Display is desplayed, inspection of the air conditioning system is necessary. Please consult author-
ized service personnel.
En-11
* Press the START/STOP button to start the air conditioner, and then
proceed as follows.
Press the VERTICAL AIRFLOW DIRECTION and SWING button to adjust
the direction of the vertical airflow. To set the swing operation, press the
VERTICAL AIRFLOW DIRECTION and SWING button for more than 2 sec-
onds. (Stop the setting by pressing for more than 2 seconds again.)
* Press the START/STOP button to start the air conditioner, and then
proceed as follows.
Press the HORIZONTAL AIRFLOW DIRECTION and SWING button to ad-
just the direction of the horizontal airflow. To set the swing operation, press
the HORIZONTAL AIRFLOW DIRECTION and SWING button for more than
2 seconds. (Stop the setting by pressing for more than 2 seconds again.)
Unit number (usually 0)
Error code
SU MO TU WE TH FR SA
ex. Self-diagnosis check