Inserting Toner - Toshiba E-studio 1105 Operating Instructions Manual

4. Adding Toner, Staples, Ring Combs and Glue
• Always add toner when the machine instructs you.
• Fault may occur if you use toner other than the recommended type.
• When adding toner, do not turn off the operation switch. If you do, settings will be lost.
• Do not repeatedly install and remove toner bottles. This will result in toner leakage.
• Do not shake the removed toner bottle. Remaining toner might scatter.
• Do not use recycled toner. This will damage the machine.
• During toner adding, the toner bottle is rotating. Do not touch the toner bottle.
• If toner remains in the bottle, you cannot remove the bottle. Do not remove the bottle forcibly.
4
• Be sure to set the new toner bottle in the lower hole first.
• Store toner containers in a cool, dry place free from direct sunlight.
• Store toner on a flat surface.
• If the message " Check toner cartridge replacement(s)." appears, the toner has almost run out. Have
a replacement toner cartridge at hand.
• You can check the name of the required toner and the replacement procedure using the " Add Toner"
screen.
• Press [System Status] to check contact number where you can order supplies. See "Checking Machine
Status and Settings", Troubleshooting
• You can still make about 200 copies after
• If one of the toner bottle is empty, you can keep copying by using the other bottle.
• You can change the toner bottle during copying.
• When you change one toner bottle, do not touch the other one.

Inserting Toner

This section describes how to insert toner.
• Do not shake the toner bottle with its mouth down after removing it. Residual toner may scatter.
• Be sure to set the new toner bottle in the lower hole first.
130
.
appears, but replace the toner early to copy degradation.