Adding Paper; Loading Paper; Loading Paper Into Tray 1 (Tandem Tray) - Toshiba E-studio 1105 Operating Instructions Manual

3. Adding Paper

This chapter describes recommended paper sizes and types, and how to load paper into the paper tray.

Loading Paper

This section describes how to load paper into the paper tray.
• When loading paper, take care not to trap or injure your fingers.
• Fan the paper before loading.
• Straighten curled or warped paper before loading.
• When paper in trays that are set to automatically eject unnecessary tab stock sheets runs out, reload
the tab stock from the beginning of the cycle (the first sheet).
• For details about paper sizes and types, see "Recommended Paper Sizes and Types".
• p.114 "Recommended Paper Sizes and Types"

Loading Paper into Tray 1 (Tandem Tray)

This section describes how to load paper into Tray 1 (Tandem tray).
• When paper loaded in the right side of Tray 1 runs out, paper on the left is automatically shifted to
the right. Do not pull out Tray 1 while the tray is moving paper; wait until sounds stop coming from
the tray.
• For the right stack, align the right edge of the copy paper with the right edge of the tray. For the left
stack, align the left edge of the copy paper to the left edge of the tray.
1
• Tray 1 uses only 8 /
• Do not stack paper over the limit mark.
× 11 paper. If you want to load A4 , contact your service representative.
2
3
85