Rear Panel Connectors - Sony DHG-HDD250 Operation Manual

Rear Panel Connectors

Connection
qd CABLE IN
qf ANT IN
qg Component Video
OUT (Y P P
)
B R
qh AUDIO OUT
qj SD OUT: VIDEO
OUT/S VIDEO OUT
qk HDMI OUT
ql CONTROL S IN
Description
Connects to a coaxial cable coming directly from your cable TV service outlet.
Connects to an over-the-air or terrestrial antenna.
Provides high-definition or standard-definition component video signal to a
Y/P /P -compatible monitor. The COMPONENT OUT connector is not
B R
available if the HDMI OUT connector is connected to an HDMI-compatible
monitor.
Provides analog audio signals to a TV or other device.
Provides standard-definition composite video signal to a DVD-Recorder, VCR
or TV set. For a better quality picture connection, use the S Video jack if it is
available.
✍
Menus and on-screen displays are available from the SD OUT connectors
only when the FORMAT setting is set to SD OUT. With other FORMAT
settings, no menus or on-screen displays are visible.
Provides an uncompressed all-digital audio/video interface between the HD
DVR and an HDMI-compatible monitor. HDMI (High-Definition Multimedia
Interface) supports either standard-definition or high-definition video, plus
up to 5.1 channels of digital audio. You can use the supplied HDMI to DVI
adapter to supply video to a monitor with a DVI-HDTV input. When using
the adapter, a separate audio connection is required.
✍
The HDMI connector has a higher priority when both the HDMI and
COMPONENT outputs are connected to a monitor(s). To enable the
COMPONENT output, disconnect the HDMI cable from the HDMI OUT
connector.
Allows the HD DVR to receive remote control signals from other Sony
infrared-controlled equipment that have a CONTROL S OUT function. For
example, it may be useful to connect to the CONTROL S OUT jack of a Sony
TV so that you may point your HD DVR remote control at the TV and remote
control commands will be passed directly to your HD DVR.
Introduction to HD Digital Video Recorder
(continued)
7