Unpacking; Removing Protective Packing Materials; Developer Unit Installation - Sharp AR-5012 Service Manual

4. Unpacking

Be sure to hold the handles on both sides of the copier to unpack the
copier and carry it to the installation location.

5. Removing protective packing materials

1) Remove pieces of tape and protective cover. Then open the origi-
nal cover and remove protective materials (a) and (b).
AR-5012
2) Release the scan head locking switch.
Grasp here and turn in
the direction of the arrow.
Lock Unlock
3) Ensure that the bypass tray is open and then open the side cover
by pressing the open button on the side cover.

6. Developer unit installation

1) 2) 3) Open the side and front cabinets of the copier.
4) Remove the locking tape of the developer unit.
5) Remove the screw which is fixing the copier and Developer unit.
6) Remove Developer unit slowly from the copier.
7) Remove the screw (1 pc).
AR-5012
8) Remove Upper developer unit.
9) Shake the aluminum bag to stir developer
10) Supply developer from the aluminum bag to the top of the MX roller
AR-5012 UNPACKING AND INSTALLATION 5 - 2
5
3
evenly.
Note: Be careful not to splash developer outside Developer unit.
2
1
4