[11] MAINTENANCE
1. Maintenance table
Section
Developing
Developer
DV blade
DV side seal (F/R)
Process peripheral
Drum
2. Maintenance display system
Toner
Life
Remaining quantity
check *1
Remaining quantity
LED
Machine
Developer
Life
LED
Machine
Maintenance
LED
Machine
*1: Installation of a new toner cartridge allows to display the remaining quantity.
The remaining toner indication is based on the number of revolutions of the toner motor.
3. Remaining toner indication
TONER FULL
100%
100-90%
89-75%
• The remaining toner indication is based on the number of revolutions of the toner motor.
• The toner END indication appears when the END is detected by the toner sensor, or when the number of revolutions of the toner motor reaches a
given number (equivalent to 8K), whichever comes first.
: Check (Clean, adjust, or replace when required.)
Parts
25K
a. Press and hold the density adjustment LIGHT key for more than 5 sec, and the machine will enter the user
program mode.
b. Press and hold the "%" key for more than 5 sec, and the remaining quantity will be displayed on the copy
quantity display in one of the following levels: (Remaining quantity display levels: 100%, 75%, 50%, 25%,
10%, LO)
c. Press the density adjustment LIGHT key to cancel.
NEAR EMPTYAbout 10%
ON
Operation allowed
25K
ON at 25K of the developer count.
Selection is available between Not Stop and Stop by Service Simulation (SIM 26-37) Setup.
(If Stop is selected, the LED will flash and stop at 25K.)
∗
Default: Not Stop
∗
Clear: SIM 24-06
Selection is available among 25K, 13K, 9K, 6K, 3K, and free (no lighting) with SIM 21-1.
∗
Default: 25K
∗
Clear: SIM 20-1
Not stop.
Remaining toner indication
75%
50%
74-50%
49-25%
AR-5012 MAINTENANCE 11 - 1
: Clean
50K
75K
100K
8K
EMPTY
Flash
Stop
Display for users
25%
24-10%
10%
NEAR END
✩
: Replace
: Adjust
125K
Remark
Lo
LOW LEVEL
10 sheets
Indicator
END
: Lubricate