Advanced Automatic Editing; Dmc Editing - Sony SRW-5000 Operation Manual

6-2 Advanced Automatic
Editing
This section describes the following advanced editing
methods:

• DMC editing

• Animation editing
• Preread editing
6-2-1 DMC Editing
®
If your player VTR has DT
capability, you can perform variable speed editing by
controlling the playback speed from the lower control
panel. This type of editing is called DMC editing.
Overview of DMC editing
Requirements for DMC editing
• DMC editing may be done during assemble or insert
editing, but not during split editing.
• The player VTR must support DT playback.
Tape movement during DMC editing
During DMC editing, the tape moves as shown in the
diagram below.
IN point
Preroll
Recorder
VTR
Playback DMC editing mode
mode
Preroll time ×
IN point
initial speed
Player
VTR
Moves at
the initial
Playback at speeds
speed.
stored in memory
(Dynamic Tracking)
OUT point
Post-roll
Stop
Playback
mode
Post-roll time ×
final speed
Stop
Moves at
the final
speed.
Setting edit points and playback speed
Use the procedure below to set edit points and playback
speeds for DMC editing.
1
3
1
Press the [F3] (ASSEMBLE) button in the HOME
menu, or press the respective INSERT button ([F4]
(INS TC), [F5] (INS VIDEO), or [F6] (INS AUDIO)
button) to select the edit mode that you want.
2
Press the PLAYER button to set the connected VTR to
act as the player VTR.
The PLAYER button lights up.
3
Press the ALT/[F7] (DMC) buttons in the HOME
menu.
The system enters DMC editing mode.
4
Press the IN button while holding down the ENTRY
button to set an edit point.
Note
You cannot set an OUT point for the player VTR for
DMC editing.
5
Press the STOP button to enter STOP mode.
6
Turn the search dial to set the initial speed.
The selected speed is displayed in the time data
display.
2
4 5
9 7 6,8

6-2 Advanced Automatic Editing

125