Sony SRW-5000 Operation Manual page 150

Item number Item
311 EDIT PRESET
REPLACE MODE
SELECT
312 ANALOG AUDIO
EDIT PRESET
REPLACE
Sub items
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH9
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH10
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH11
ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH12
317 AUDIO EDIT MODE cut edit
318 EDIT RETRY
150
Menu List
Setting Function
[normal] normal: Assigns edit preset command channels 1 to 8, to
parallel
reverse parallel: Assigns edit preset command channels 1 to 4, to
stereo
reverse: Assigns edit preset command channels 1 to 4 to
stereo: Assigns edit preset command channels 1 to 4 to
[no def]
When the edit presets for VTR channels 9 to 12 are
ch1 specified by an editor or remote controller, these are set on
ch2 or off according to the analog audio edit presets.
ch1+2 no def: Not set.
ch1: Follows analog channel 1 edit preset.
ch2: Follows analog channel 2 edit preset.
ch1+2: Follows the edit preset for analog channel 1 or
Specifies the type of editing for digital audio signals.
[cross fade] cut edit: Cut editing (discontinuity in audio signal may result
fade in/out at the join, causing noise.)
cross fade: Cross-fade (see figure below.)
fade in/out: Fade-out and fade-in (see figure below.)
CROSS FADE
FADE IN/OUT
Notes
• The "t" in the figures above is the time set by item 811.
• When editing non-audio data, be sure to select "cut edit".
• Noise may be produced during the editing of certain non-
off Set this item when the VTR is used as a recorder during
[on] VTR-to-VTR editing. Specifies the action taken when the
recorder fails to synchronize with the player VTR.
off: Editing is not executed and the VTR enters STOP
on: The VTR automatically repeats the editing (not more
track channels 1 to 8.
channel pairs 1/5 to 4/8.
channels 5 to 8, and channels 5 to 8 to channels 1 to 4.
track channel pairs 1/2 to 7/8.
analog channel 2.
IN
PB
INPUT
t
IN
PB
INPUT
t
audio data.
mode.
than twice).
OUT
t
OUT
t