Fujitsu Q802 Operating Manual page 20

Installing the NAS
Use the Select button to select further options, e.g. RAID 6.
Proceed as follows to select a standard drive configuration:
► Press Enter.
The following message is displayed:
C h o o s e
► Use the Select button to select Yes.
► Confirm your selection by pressing Enter.
When you execute RAID 1, RAID 5, RAID 6 or RAID 10 configuration, the system will initialize the
hard drives, create the RAID device, format the RAID device, and mount it as a volume on the NAS.
The progress will be shown on the LCD panel.
When it reaches 100 %, you can connect to the RAID volume, for example, create folders and
upload files to the folders on the NAS.
In the meantime, to make sure the stripes and blocks in all the RAID component devices are ready,
the NAS will execute RAID synchronization and the progress will be shown on Disk Management -
Volume Management page. The synchronization rate is around 30-60 MB/s (varies depending on the
hard drive models, system resource usage, etc.)
If a member drive of the RAID configuration is lost during synchronization, the RAID device
i
will switch to a degraded mode. You can continue to access the drive data.
If you insert a new member drive in the device, the drive is restored. You can check the
status on the Volume Management page.
If Encrypt Volume? is displayed on the LCD screen, select Yes if you wish to encrypt the data carrier.
The default selection is "No".
The default encryption password is admin. To change the password, login the web-based
administration interface of the NAS with an administrator account and change the settings in Disk
Management – Encrypted File System.
E n c r y p t
The data encryption functions may not be available in accordance to the legislative
i
restrictions of some countries.
14
R A I D 5 ?
N o
V O L U M E ?
N o
Fujitsu