Fujitsu Q802 Operating Manual page 28

Installing the NAS
Fujitsu Finder detects the NAS in the network and asks whether Quick Setup should be run.
► Click on Yes to continue.
If the NAS could not be found, please click on Refresh to retry.
i
Check that you have installed a hard disk in the NAS.
If you have already set up the NAS via the LCD panel, you do not have to perform the
i
following steps of the Quick Setup.
Note that during NAS set up, the installed hard disk will be formatted and all the data on it
!
will be lost.
The first page of the Quick Configuration wizard will be displayed.
► Click on Start to start the configuration process.
The configuration process may take up to twenty minutes if the hard disk used has a
i
capacity greater than 500 GB.
► Follow the instructions for initial configuration.
22 Fujitsu