Table of Contents
Advertisement
Important !
You must terminate the call
ƒ
by pressing
. Otherwise,
the panel may not discon-
nect from the phone line for
up to 2 minutes.
Note
The X-10 Siren must be set
to unit #9 to "hear" emer-
gency alarms.
41
‚
4. Press
and the panel voice identifies the alarm. If there is more than one alarm in
progress, the panel voice identifies all of them.
5. After listening to the alarm information, press
X-10 Operation
The following sections describe how to test X-10 Lamp, Siren, Appliance, and Universal Mod-
ule operation.
Manual Lamp Module Control
•
Control Panel: Press the Lights On button and the unit # of the lamp module using the
numeric buttons to test individual lamp modules 2, 4, 6, and 8. The panel responds with
Lights # on/off.
Press the Lights On button twice to turn on all lamp modules. Press the Lights Off button
twice to turn off all lamp modules.
•
Keychain Touchpad: Press the LIGHT button repeatedly to turn all lights on and off. The
panel responds with Lights on/off.
•
Remote Handheld Touchpad: Press the Lights On button and the unit # of the lamp
module using the numeric buttons to test individual lamp modules 2, 4, 6, and 8. The panel
responds with Lights # on/off.
X-10 Siren and Lamp Module Functions
All sirens turn off when the system is disarmed or when the siren timeout expires. Siren prior-
ity is as follows:
1. Fire (highest priority)
2. Intrusion
3. Emergency
If an alarm of greater priority occurs during an alarm of lower priority, the greater priority
alarm sirens sound. Fire alarms sound a temporal 3 pattern (0.5 seconds on, 0.5 seconds off for
three beeps then 1.5 seconds off).
Alarm Siren and X-10 Light Information
X-10 Lights
X-10 Siren
Interior & Panel Siren
Exterior Siren
ƒ
to terminate the call.
Fire
Intrusion
Steady
Flashing
Steady
Steady
Temporal 3
Steady
Temporal 3
Steady
Euro Simon Security System
Emergency
Steady
Alarm beeps
Fast on/off
Advertisement
Table of Contents
