Remote Control; Battery Installation - Sharp HT-SB32D Operation Manual

Remote control

■ Battery installation

1
While pushing the locking tab to-
wards the center of the remote con-
trol, slide out the battery holder.
Locking
2
Remove the old battery from the
battery holder, insert the new bat-
tery and then slide the battery hold-
er back into the remote control.
Battery holder
Polarity (+)
symbol
Battery type
Locking tab
Precautions for battery use:
Remove the battery if the sound bar will not be
used for a long period of time. This will prevent
potential damage due to battery leakage.
Caution:
Do not use rechargeable battery (nickel-
●
cadmium battery, etc.).
Danger of explosion if battery is incorrectly
●
replaced.
Replace only with the same or equivalent
●
type.
Batteries (battery pack or batteries installed)
●
shall not be exposed to excessive heat such
as sunshine, fire or the like.
Installing the battery incorrectly may cause
●
the sound bar to malfunction.
Back of
remote control
tab
Positive (+)
side up
Notes concerning use:
Replace the battery if the operating distance
●
is reduced or if the operation becomes er-
ratic. Purchase "CR 2025", coin lithium
battery.
Periodically clean the transmitter on the re-
●
mote control and the sensor on the sound
bar with a soft cloth.
Exposing the sensor on the sound bar to
●
strong light may interfere with operation.
Change the lighting or the direction of the
sound bar if this occurs.
Keep the remote control away from mois-
●
ture, heat, shock, and vibrations.
■ Test of the remote control
The remote control can be used within the range
shown below:
Remote sensor
0.2 m - 6 m
11
SOUND BAR HOME THEATRE SYSTEM HT-SB32D
ON/
MUTE STAND-BY
SOUND MODE
CINEMA MUSIC NEWS
BYPASS SURROUND INPUT
TV
VOL CH
VOL
RRMCGA322AWSA