D-Link DKVM-IP1 User Manual page 115

1. Download the firmware file to the Remote computer. You can obtain the latest firmware
from the D-Link website. After downloading the firmware, you may need to unzip the file
before uploading it to the DKVM-IP1.
2. Upload the new firmware file onto the DKVM-IP1 unit by clicking the Browse button,
selecting the firmware file, then clicking the Upload button.
Once the firmware file has been uploaded, the DKVM-IP1 will check to see whether or
not it is a valid firmware file and if there were any transmission errors
error, the update process will be aborted.
3. If the upload was successful, the Firmware Update panel will appear:
This panel shows you the version number of the DKVM-IP1's current firmware and the
v ersion of the uploaded firmware. Clicking the Update button will proceed to update the
DKVM-IP1 with the new firmware. The update process may take a few minutes to
complete.
WARNING: The update process cannot be stopped once it has started. D
process, do not disconnect power or the Etherne
update process to fail, and may cause damage to the flash memory of the
DKVM-IP1, causing it to be unusable. It is critical that the DKVM-IP1 has
uninterrupted power during the update process.
4. After the firmware has
you will be redirected to the login page automatically. Log in and check the device
information page (Maintenance > Device Information) to confirm that the updated
firmware is installed.
been updated successfully, the device automatically reboot, and
114
. In case of any
t cable, as it may cause the
uring this