D-Link DKVM-IP1 User Manual page 90


HTTP port
Here you can set the port the DKVM-IP1 will use for the HTTP server. If this is blank, the
default port of 80 will be used.

Telnet port
Here you can set the port the DKVM-IP1 will use for the Telnet server. If this is blank, the
default port of 23 will be used.

SSH port
Here you can set the port the DKVM-IP1 will use for the SSH server. If this is blank, the
default port of 22 will be used.

Bandwidth Limit
This lets you limit the bandwidth used by the DKVM-IP1. If this is blank, no bandwidth limit
will be applied.

Enable Telnet access
This enables the Telnet function.

Enable SSH access
This enables the SSH (Secure Shell) function.

Disable Setup Protocol
Enable this option to exclude the DKVM-IP1 from the setup protocol. Setup protocol is a
proprietary layer-2 MAC-based protocol to allow some configuration software to detect
DKVM-IP1 devices in the network, even without an IP address, and then configure
network related settings for the DKVM-IP1.
89