Configuring Snmpv3 Users; Figure 42 - Snmpv3 User Configuration; Table 44 - Snmpv3 Groups; Table 45 - Snmpv3 Users - D-Link DWL-2600AP Administrator's Manual

Unified Access Point Administrator's Guide
Field
Read Views
SNMPv3 Groups
Note: After you configure the SNMPv3 Groups settings, you must click Apply to apply the changes
and to save the settings.

Configuring SNMPv3 Users

From the SNMPv3 Users page, you can define multiple users, associate the desired security level to each user, and
configure security keys.
For authentication, only MD5 type is supported, and for encryption only DES type is supported. There are no default
SNMPv3 users on the UAP.
The following table describes the fields to configure SNMPv3 users.
Field
Name
Group
Authentication Type Select the type of authentication to use on SNMP requests from the user:
Authentication Key
Encryption Type
Encryption Key
SNMPv3 Users
January 2015
Description
Select the read access to management objects (MIBs) for the group:
•) view-all — The group is allowed to view and read all MIBs.
•) view-none — The group cannot view or read MIBs.
This field shows the default groups and the groups that you have defined on the AP. To
remove a group, select the group and click Remove.

Table 44 - SNMPv3 Groups

Figure 42 - SNMPv3 User Configuration

Description
Enter the user name to identify the SNMPv3 user.
User names can contain up to 32 alphanumeric characters.
Map the user to a group. The default groups are RWAuth, RWPriv, and RO. You can define
additional groups on the SNMPv3 Groups page.
•) MD5 — Require MD5 authentication on SNMPv3 requests from the user.
•) None — SNMPv3 requests from this user require no authentication.
If you specify MD5 as the authentication type, enter a password to enable the SNMP agent
to authenticate requests sent by the user.
The passphrase must be between 8 and 32 characters in length.
Select the type of privacy to use on SNMP requests from the user:
•) DES — Use DES encryption on SNMPv3 requests from the user.
•) None — SNMPv3 requests from this user require no privacy.
If you specify DES as the privacy type, enter a key to use to encrypt the SNMP requests.
The passphrase must be between 8 and 32 characters in length.
This field shows the users that you have defined on the AP. To remove a user, select the
user and click Remove.

Table 45 - SNMPv3 Users

Section 6 - Configuring SNMPv3
Unified Access Point Administrator's Guide
Page 77